The GDValet Switch PCB is a 2 sided, 2.90 x 1.25 hybrid thru hole / SMT board. The board can support 5 normally open contact momentary push w/gnd switches or a single 4 direction normally open contact with center push switch, both being thru hole. The SMT version of the 4 direction switch has been installed and tested at the thru hole location and worked great. Either setup can have the 6 pin thru hole SIP or the RN7 pin SMT installed. If either of these parts are installed, then the 10k pull-up resistors (R13 - R17) on the GDV controller 8200-10 Rev. C and above can be eliminated.
Note: Even with all the 10k resistors installed, the unit still passed all functional test. Your results may vary.

Five (5) VDC comes in on pin 1 of the 2 x 5 connector to both of the 10K pull-up resistors. The 2 mounting holes are 2.6 inches apart and connected to gnd on J1 pins 3, 5, 7, and 9, back to the GDValet controller.
The "SIP" can be mounted on either side of the Switch PCB.
NOTE: Each GDV SB kit order includes one(1) Switch Cable.
garagedoorvalet011011.jpg garagedoorvalet011010.jpg
About the GDV Switch Board Design.
Now compatible with Parallax 5 Position Switch Item: 270801.
This Security / Educational kit is for any resident with a Motorized Garage Door. When completed and connected, it can be set to automatically close a standard single home Garage Door as though you were there pushing the button. With the Micro-Controller, clock chip, other components and the free downloadable program, you will be able to set / change the monitoring "Start - Stop" hours or put in a 24 hour continuous monitoring mode.
These are just a few of the features.

Full Assembly / Operational details are downloadable from the Resources Link.




flag_usa.gif flag_usa.gif garagedoorvalet002002.gif
Copyright 2010 - 2015 LittleHM,LLC - All Rights Reserved
Click for Link.
garagedoorvalet011002.jpg garagedoorvalet011001.jpg